I started working on 3D printing the "Dave" but I decided there were too many engineering items to overcome for a first time (lots of struts.) This is simpler. I don't need an engine, the LG are hidden in wheel pants, etc.
Ryan ST/STA/STM
-
denders
- Super Moderator
- Posts: 62
- Joined: Fri May 19, 2006 1:15 pm
- Location: Fairview, Tennessee
- Primary Application: modo
Ryan ST/STA/STM
I started this a long time ago. Thought I'd work on it again.
I started working on 3D printing the "Dave" but I decided there were too many engineering items to overcome for a first time (lots of struts.) This is simpler. I don't need an engine, the LG are hidden in wheel pants, etc.
I started working on 3D printing the "Dave" but I decided there were too many engineering items to overcome for a first time (lots of struts.) This is simpler. I don't need an engine, the LG are hidden in wheel pants, etc.
Dave
-
Skyraider3D
- Super Moderator
- Posts: 14
- Joined: Sat Aug 27, 2022 8:39 pm
- Contact:
Re: Ryan ST/STA/STM
Super nice subject 
